Application Areas - CAM - MILLING

Manufacturing Set: The Manufacturing Set consists of: I-DEAS® Generative Machining™. The integrated module for the creation of NC tool paths on I-DEAS models. This module works directly on solid or surface geometry created within, or imported into, I-DEAS. Its integrated nature enables NC Programmers to take full advantage of the associativity that is part of all I-DEAS modules. Design changes that occur after the NC tool path is created will be flagged, and at the discretion of the programmer, are updated to conform to the new geometry. I-DEAS C-Post. Allows you to create standard or custom post-processors for any modern NC machine/control combination. Advanced Manufacturing Set: The Advanced Manufacturing Set expands the capabilities of the Manufacturing Set and includes Camand® Multax. The Advanced Manufacturing Set is targeted for the airframe, turbo machinery, prototype machining, 5-axis trimming and routing markets where 5-axis simultaneous machining is the requirement. Strong simulation of the machine motion and post-processing are both critical capabilities for these markets and Camand Multax excels in these areas. Mastercam Mill Level 1: CAD/CAM system for 2 ½ axis machining and design, includes Mastercam Design functionality, plus: Fully associative contouring, pocketing and drilling Automated pocket remachining and island facing Tombstone programming Solids-based toolpath verification Feed rate optimization for constant volume removal and smooth cornering Editable tool and material liberaries. More details Mastercam Mill Level 2: CAD/CAM systems for 3-axis machining and design, includes Mastercam Design & Level 1 functionality, plus: Single-surface and single solid-face roughing and finishing, including flowline Toolpath projection onto a complex surface Ruled, swept, ansd revolved toolpaths More Details Mastercam Mill Level 3: CAD/CAM systems for 2 through 5-axis milling, includes Mastercam Design, Level 1 & 2 functionality, plus: Unlimited surface and solid roughing and finishing Constant Z-level and plunge roughing Multisurface remachining, pencil tracing, and constant scallop machining Containment and multisurface flowline machining More Details